RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 655 views POST REPLY
Scorpion Power Scorpion Power
HelicopterThunder TigerOther › Raptor30v2 building question??
03-14-2003 05:39 PM  14 years agoPost 1
Helicopter J

rrApprentice

Winchester,VA

My Posts: All  Forum  Topic

Hey fellows i just got my new raptor 30 v2 and i was wondering when u put the pinion gear into the clutch bell do u use loctite?? And when building this heli do i put grese on all the bearings?? Kinda think i would but wanna make sure?


Thanks

"Keep the grass level"

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR
03-14-2003 06:26 PM  14 years agoPost 2
Bird_E

rrApprentice

Erie, CO

My Posts: All  Forum  Topic

I would not recommend it

If you ever need to remove the clucth bell to work on it, you can do it without splitting the frames, IF the bell unscrews easily. However, if you locktite it you will most likely have to split the frame to take it apart. Infact I put a little grease on the threads and make sure it screws on and off very easily. It will never come off by itself because motor torque will keep it tight.

my .02
Bob

PM  EMAIL  GALLERY  Attn:RR
03-14-2003 11:34 PM  14 years agoPost 3
Helicopter J

rrApprentice

Winchester,VA

My Posts: All  Forum  Topic

Thanks

Thanks allot guys for the help keep added replys.

~FlipMaster J~

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR
WATCH
 1 page 655 views POST REPLY
Scorpion Power Scorpion Power
HelicopterThunder TigerOther › Raptor30v2 building question??
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Sunday, September 24 - 2:10 am - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online