RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 350 views POST REPLY
Scorpion Power Scorpion Power
HelicopterRadio - Servo - Gyro - Gov - Batt › E Flight G90 Creeps
12-02-2007 07:00 PM  9 years agoPost 1
cwright

rrKey Veteran

Blossvale New York

My Posts: All  Forum  Topic

I am trying to setup a G90 gyro with a Futaba 3154 servo on a Gaui 200 for a friend. When I am in heading the servo creeps to give the heli right input. It does not do this in normal or rate mode. What might be causing this? Also we are using a DX7 and have the gain plugged into the gear channel. We also have the gear switch set to gear. Thanks Chuck

PM  EMAIL  GALLERY  Attn:RR  Quote
12-02-2007 09:30 PM  9 years agoPost 2
baddynergy

rrElite Veteran

sierra madre, ca- usa

My Posts: All  Forum  Topic

Do you have any trim or subtrim in your rudder channel??

**Unattended children will be givin a shot of espresso and a puppy**

PM  EMAIL  GALLERY  Attn:RR  Quote
12-02-2007 09:33 PM  9 years agoPost 3
Micro-Maniac

rrElite Veteran

Pasco,Washington Formerly: Captain Chaos

My Posts: All  Forum  Topic

Yep it's just a drifty piece of junk of a gyro - It requires some trim or sub-trim to start with then it'll accumulate more creep as the flight goes on requiring more and more trim to compensate - When it's starts to creep you can reboot the gyro and it'll recenter so I have no clue what the cause is - Most everyone's G90 does it though

PM  EMAIL  GALLERY  Attn:RR  Quote
12-03-2007 03:33 AM  9 years agoPost 4
cwright

rrKey Veteran

Blossvale New York

My Posts: All  Forum  Topic

No sub trim or trim in the rudder. I guess he should just install a 401. Thanks Chuck

PM  EMAIL  GALLERY  Attn:RR  Quote
12-03-2007 03:37 AM  9 years agoPost 5
Micro-Maniac

rrElite Veteran

Pasco,Washington Formerly: Captain Chaos

My Posts: All  Forum  Topic

That's exactly what I did - Problem solved

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 350 views POST REPLY
Scorpion Power Scorpion Power
HelicopterRadio - Servo - Gyro - Gov - Batt › E Flight G90 Creeps
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Tuesday, October 24 - 6:53 am - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online