RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 578 views POST REPLY
Scorpion Power Scorpion Power
HelicopterBeginners Corner › dx7 with walkera 60 setup
12-02-2007 05:19 AM  9 years agoPost 1
Miguel

rrNovice

Quebec, Canada

My Posts: All  Forum  Topic

I've try to set up my walkera 60 with a dx7 tx from a t-rex post I found on the runryder forums.
I think i did well because the swashplate seems to match my tx movements.
There is just a small (or big) problem. when I apply throttle more than 20% the engine seems to stop, my ESC light blink and the Rx (ar6100) light (orange) switch off. Then, I move back the throttle to 0, and usually the rx and ESC light light on again (and do the same thing each time i apply more than 20% throttle).

It seems like "safe something" device that stop all from responding. Do someone have any idea what can be wrong ??

Miguel

PM  EMAIL  Attn:RR  Quote
12-02-2007 02:44 PM  9 years agoPost 2
Miguel

rrNovice

Quebec, Canada

My Posts: All  Forum  Topic

Yes, I'M using walkera ESC and servo for now.
Prior to setup the swashplate correctly i can gave full power at it with the dx7 and ar6100 receiver. but now that i've setup my swash, i can't ggo more than 20% without al cuttting off.

PM  EMAIL  Attn:RR  Quote
WATCH
 1 page 578 views POST REPLY
Scorpion Power Scorpion Power
HelicopterBeginners Corner › dx7 with walkera 60 setup
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Tuesday, October 17 - 9:46 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online