RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 725 views POST REPLY
Scorpion Power Scorpion Power
HelicopterSynergy R/CSynergy N9 › N9 Clutch Lining
12-02-2007 05:05 AM  9 years agoPost 1
bullseye1

rrApprentice

Orange County, ca

My Posts: All  Forum  Topic

my clutch went out on my N9 today, what is the proper way to replace the lining?
should i replace the clutch assy. at the same time.
Thanks,

PM  EMAIL  GALLERY  Attn:RR  Quote
12-02-2007 09:02 AM  9 years agoPost 2
Paul Susbauer

rrApprentice

Hillsboro, OR

My Posts: All  Forum  Topic

Pull out the remaining bits of clutch liner, scrape it clean of any. Get the blue Hirobo liner.

Wrap the clutch in two layers of masking tape (I used the special green painters tape) which made a nice tight tolerance.

I used JB weld, carefully coating the inside of the clutch. The liner was carefully cut to the proper length, not allowing any gap. Then it was put in, with the clutch slipped into hold it in place. After I pushed it in, I carefully popped the clutch back out and cleaned off any JB weld that may have squeezed out on the inside of the clutch bell.

Reinserted the clutch/tape assembly, let cure for 24 hours. Removed clutch, removed tape from clutch. Trimmed any excess liner to make it flush with the bell. Installed in heli...nice and smooth.

--Paul

Ineptitude - If you can't learn to do something well, learn to enjoy doing it poorly.

PM  EMAIL  GALLERY  Attn:RR  Quote
12-02-2007 10:49 PM  9 years agoPost 3
bullseye1

rrApprentice

Orange County, ca

My Posts: All  Forum  Topic

Paul, thanks a lot for the info and step by step instructions, I do have the Hirobo lining so I'm getting started right a way.
Mike,

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 725 views POST REPLY
Scorpion Power Scorpion Power
HelicopterSynergy R/CSynergy N9 › N9 Clutch Lining
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Sunday, October 22 - 7:58 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online