RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 578 views POST REPLY
Scorpion Power Scorpion Power
Helicopter
e-
Thunder Tiger
Raptor E325 › Kasama mixing arms
11-27-2007 04:26 AM  9 years agoPost 1
TerranAce007

rrVeteran

Austin, TX

My Posts: All  Forum  Topic

Santa came early this year, dressed up as a UPS guy. I have my mini titan kit spread out on the table and am just getting started with the build. I figured I would just throw on the kasama mixing arms from the start, but now the flybar case does not fit. Am I supposed to use the longer bolts and spacers that come with the mixing arms, or do I use the mounting screws from the stock arms? Anyone have a close-up pic?

PM  EMAIL  GALLERY  Attn:RR  Quote
11-30-2007 05:37 PM  9 years agoPost 2
Wheelhaus

rrVeteran

Denver

My Posts: All  Forum  Topic

the Kasama bell/hiller mixing arms are designed to be used with their flybar carrier, which goes through the center of their head block. look at a picture of the fully assembled head and you'll see what I'm talking about. You may only need to get the flybar control arms, but I'd suggest get the whole head since its designed to work as a set.

..........
Dave

PM  EMAIL  Attn:RR  Quote
11-30-2007 07:07 PM  9 years agoPost 3
TerranAce007

rrVeteran

Austin, TX

My Posts: All  Forum  Topic

Well, I didn't realize they were not compatible with the stock setup until trying to assemble them. I just built the stock head for now and will see if I have any tracking issues. If I flip the kasama arms around and get a small spacer, it looks like they will work. The kasama head looks nice and might be an eventual upgrade, but for now I don't have the $$ to blow on it. That's why I went with the Mini-T and not the T-Rex 450SE.

PM  EMAIL  GALLERY  Attn:RR  Quote
12-01-2007 11:51 AM  9 years agoPost 4
dynodude

rrNovice

El Cajon, ca

My Posts: All  Forum  Topic

Get the Align upper and lower arms. At $26.00 it's cheaper than buying the rest of the Kasama head and they work great with all the stock plastic. You will also need a couple of larger link balls and rod ends.

PM  EMAIL  GALLERY  Attn:RR  Quote
12-01-2007 12:55 PM  9 years agoPost 5
AMainMaker

rrKey Veteran

Nappanee,IN

My Posts: All  Forum  Topic

I still use the stock plastic mixer arms for almost a year now and have no tracking issues at all. The only part I upgraded to metal was the main rotor hub and the washout base only cause the plastic ones were starting to wear and get sloppy.
Jason

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 578 views POST REPLY
Scorpion Power Scorpion Power
Helicopter
e-
Thunder Tiger
Raptor E325 › Kasama mixing arms
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Saturday, October 21 - 7:31 am - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online