RunRyder RC
 2  Topic Subscribe
WATCH
 1 page 456 views
Scorpion Power Scorpion Power
HelicopterEngines Plugs Mufflers Fuel › I think my engine leans itself
09-10-2007 04:32 PM  10 years agoPost 1
helikinesis

rrApprentice

Grand Forks, North​Dakota

My Posts: All  Forum  Topic

I set my needles and all was good. About a gallon later i noticed the headspeed was awful high. i eventually figured out my motor was just leaning out on its own and the high end needle had crawled in almost 3/4 of a turn! Anyone else have this happen to them or is it a common thing?

Can't get your blades to track? Scuff 'em.

PM  EMAIL  GALLERY  Attn:RR  Quote
09-10-2007 04:37 PM  10 years agoPost 2
JEEPWORLD2002

rrKey Veteran

BLUEBELL PA USA

My Posts: All  Forum  Topic

check and make sure the oring has not balloned it may have swelled and is now thicker which in turn wont let the needle go in as far ??

PM  EMAIL  Attn:RR  Quote
09-11-2007 01:05 AM  10 years agoPost 3
airdodger

rrElite Veteran

Johnston USA

My Posts: All  Forum  Topic

Bend the detent spring so the contact point applies more pressure on the needle.

Chris

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 456 views
Scorpion Power Scorpion Power
HelicopterEngines Plugs Mufflers Fuel › I think my engine leans itself
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Thursday, November 23 - 12:51 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online