RunRyder RC
 0  Topic Subscribe
WATCH
 1 page 572 views
Scorpion Power Scorpion Power
HelicopterAlignOther › end points and swashplate??
08-10-2007 10:21 PM  10 years agoPost 1
brifa

rrApprentice

ITALY

My Posts: All  Forum  Topic

Dear all
i'd like to know wich value i have to set on my futaba 7cp for channel 4 (rudder) end point
somebody told me to set it at max value (140)

and i noted that when i give full pitch the hely doesn't go up levelled
i should level the swashplate but in which way??
thanks

PM  EMAIL  Attn:RR  Quote
08-10-2007 10:33 PM  10 years agoPost 2
702nitro

rrKey Veteran

Las Vegas, NV

My Posts: All  Forum  Topic

Rudder end points control the pirouette speed. You can start off with 100 on both ends and adjust accordingly(lower value = slower higher= faster)

PM  EMAIL  GALLERY  Attn:RR  Quote
08-10-2007 10:53 PM  10 years agoPost 3
hampilot

rrApprentice

Sparks, NV USA

My Posts: All  Forum  Topic

end of my point

I was always under the impression that you would adjust your end points to full travel of the rudder itself, depending on the gyro and if it has a travel setting, in which case you would set your end points on ch 4 to 100 and adjust your travel in the gyro.

as far as the swash being level, it should be. get a swash leveler, it makes things so much easier.
[url=http://truebloodengineering.com/modules.php?name=Content&pa=showpage&pid=1]

PM  EMAIL  GALLERY  Attn:RR  Quote
08-10-2007 11:31 PM  10 years agoPost 4
kingair

rrKey Veteran

Utah - USA

My Posts: All  Forum  Topic

With a swash leveler you can check for interaction at the extreme ends of throw. I think the trueblood swash leveler is the quickest, easiest and most accurate way to set up the swash but if you don't have a swash leveler check out this post:

http://www.runryder.com/helicopter/p1297231/

This person explains how to level the swash and check for interaction with a pitch gauge. I found it to be a very interesting way for set up.

There is a very fine line between "hobby" and "mental illness."

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
08-11-2007 08:57 AM  10 years agoPost 5
brifa

rrApprentice

ITALY

My Posts: All  Forum  Topic

i have a 611 with 9256 and this setting:
25% gain
travels 115% both ways
Control Delay I (Rudder Stick Operated), Right and Left = 15
Control Delay D (Rudder Stick Returned), Right and Left = 50
3d mode
cmt mode
3rd hole out from center on 4 star servo horn

i think that end point must be settled to max
it's very fast in this way

PM  EMAIL  Attn:RR  Quote
WATCH
 1 page 572 views
Scorpion Power Scorpion Power
HelicopterAlignOther › end points and swashplate??
 Print TOPIC  Make Suggestion 

 0  Topic Subscribe

Wednesday, November 22 - 4:03 am - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online