I have for sale an X-Cell 99 SE. For the most part this is a stock 99 SE with one or two upgrades added. Added were a metal tail rotor gearbox ( the metal pitch change parts are stock SE parts ), newer tail rotor hub, machined metail rails along the bottom of the lower frames ( originals were aluminum bent 90 degrees ). It has been upgraded with a YS80 as well which means it has a new clutchbell and 11 tooth pinion to give it the proper 8.45:1 gear ratio required for the YS80 to preform right.
The heli is in good shape and flies nice. It does show signs of use like the odd ding or scratch. It has the stock full metal SE rotor head with all the gold parts. The tail rotor system is all stock SE parts except for the metal tail rotor gear box. Other features are full carbon frames including the SE servo tray, heavy duty transmission upgrade, carbon boom, carbon boom supports, carbon torque tube, rear mounted tail rotor servo, constant driven tail rotor. the tail fins are the stock SE white gel coated carbon fins. The muffler is a a MP2 which I will admitt I did not have much luck with. The canopy has a base coat/ clear coat paint job and is in great shape. The YS80 has good compression and runs good and does not have a lot of flight time on it. The fuel lines are all new as a week ago as well is the YS check valve and the Century fuel filter.
Included with the heli is a set of MAH 690mm carbon blades, tail rotor blades are stock X-cell plastic blades, two spare tail booms, two spare torques tubes, one used but still good main shaft, used set of clutch dampeners, clutch spacing tool, one used 90 tooth main gear that is in good shape, psare upper frames, upper and lower main shaft bearing blocks, spare swash plate guide, spare metal elevator swing arm set, spare heavy duty tail rotor transmission upgrade, spare o-rings for the rotor head, spare pitch bellcrank that mounts in the servo tray. Most of the spare parts are new and have never been used.
The following new parts are included as well. One spare 93 tooth main gear, two new crown gears, two new tail rotor output shafts, two new main shafts, one new spindle shaft, new spare o-rings for a YS80 needle valves, one spare new clutch with start shaft. Also included are the plans for the heli. They are in good shape as well and are not torn.
***Not included are any servos, gyro, governor or receiver. In short no electronics at all. ***
I really hate to sell this one as it is a very nice machine but my Predator SE gasser gets all the flying fun now.
I am asking $600 for the whole works plus shipping. I do not wish to make any trades but if it does not sell as a lot I may consider parting it out.New Price of $550 shipping included.
I will also consider parting it out as if it does not sell here I will be sending it off to ebay.