RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 489 views
HelicopterBeginners Corner › Need help setting up
01-27-2007 07:46 PM  10 years agoPost 1
spr250

rrNovice

Superior, WI USA

My Posts: All  Forum  Topic

Ok, here is the deal, I have a nexus 30 that I never flew. The problem is I've flown them back in high school with my shop teacher but since he took care of them I never had to them set up. What Im asking is how so you adjust the pitch for the main rotors and tail rotors. Also how do you make sure the controler is setup the way it needs to be for settings. My radio is a Futaba Skysport 6H FP-T6VH with a Heli Max Rate Adjuster and Heli Max Dual Rate Ball Bearing Gyro. So if any one can help me out, I'd appreciate it. Thank You.

Pay your taxes on time, I need a raise

PM  EMAIL  Attn:RR
01-28-2007 09:55 PM  10 years agoPost 2
JRjoe

rrElite Veteran

Jonesville , IN USA #1

My Posts: All  Forum  Topic

I'm afraid to touch this one. Ball bearing gyro??? I think you might have some really out dated stuff there. Your gonna probably need to find someone local to help you out. Might also think about updating your equipment. Just my 2 cents..............


JRjoe.....
Indoor plumbing??? No, we don't need that!!!

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR
01-29-2007 02:23 AM  10 years agoPost 3
bmw

rrApprentice

Lake Zurich U.S.A.

My Posts: All  Forum  Topic

Are you sure that it is not a ball bearing servo and not the gyro??

Runway? what runway??

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR
01-29-2007 03:20 AM  10 years agoPost 4
crash-

rrVeteran

Ca

My Posts: All  Forum  Topic

Ball bearing gyro that old.
Just set up a heli just like your about a year ago.
I set it up for half stick hover
Pitch was set -2 5 9
That radio has to be set up mechanically.
Hope I rember right.
Set your stick mid stick on pitch,throttle.
Use star horn and set it to 90 degree to pitch arm.
2nd hole on servo star should be ball placement
after rotating the servo star.
Move your star 1 notch towards pos pitch
rotate star 180 degree and set it towards pos pitch.
this will give you a one and a half spline off set to
pos pitch.
set ball or z bent now.2nd hole
Set the pitch a half stick 4 to 5 on mains blades.
This should give you -2 to 9 hover at 5
Thottle set a half stick at 90 to engine linkage.
Engine linkage 90 to servo at half barrow open
Move your star wheel one spline to Idle and put
rod on ajust for full close and open with trim slider
all the way down.
This set up is for upright flying
hope this helps.

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR
WATCH
 1 page 489 views
HelicopterBeginners Corner › Need help setting up
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Friday, December 15 - 12:11 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online