RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 282 views
HelicopterRadio - Servo - Gyro - Gov - Batt › Revmax setup on ff9super
01-26-2007 07:50 AM  10 years agoPost 1
Maxime

rrApprentice

Belgium

My Posts: All  Forum  Topic

Hi,
I recently purchased a revmax and was able to go through the easy setup. I put my idle up 2 full 100%, and on switch C(3 positions) I had 2 different ATV's(so 2 different governed headspeeds and 1 cut-off on the same switch) on channel 7(revmax aux in channel 7 also). Idle up 1 is still a true throttle V-curve.

But now I would like to be able to use the governor menu in the ff9 super so that idle up 1(also full 100% curve) is governed at a certain ATV, and that idle up 2(100%) is also governed at a higher RPM through the governor menu, but can't seem to get it to work right on the bench, so I won't test it in flight without being sure.

The problem is that the cut-switch doesn't work, however it was assigned to switch B(green light on revmax doesn't go off), and everything was set up like explained underneath. Don't think it's safe that the green light doesn't go off when I tell it to with the assigned switch

So, for governor menu, put aux cable from revmax to channel 8? governor menu ACT, put menu to channel 8, channel 8 in endpoints (95/95 I was told), assign cut switch to B for example, next page in the ff9, assign to condition(this was only possible in channel 8, channel 7 didn't have condition), put values NORM:0%, Idle 1:+/-60, Idle 2:+/-70(example percentages according to wanted headspeed)

so this should be it, except the cut switch doesn't work. Could anyone help me?

PM  EMAIL  Attn:RR  Quote
WATCH
 1 page 282 views
HelicopterRadio - Servo - Gyro - Gov - Batt › Revmax setup on ff9super
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Friday, December 15 - 2:17 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online