RunRyder RC
 4  Topic Subscribe
WATCH
 1 page 621 views
Helicopter
e-
Blade
Other › blade cp brushless upgrade with a dx-6 ?
01-22-2007 09:11 PM  10 years agoPost 1
gordon stott

rrNovice

longwood,fl seminole

My Posts: All  Forum  Topic

how do i get gyro/ tail rotor mixing while hooking up a brushless with a dx-6 radio on a blade cp using the existing 3 in 1?

PM  EMAIL  Attn:RR  Quote
01-22-2007 09:59 PM  10 years agoPost 2
stickyfox

rrKey Veteran

Rochester, NY - US

My Posts: All  Forum  Topic

You probably want to get a y-cable to run the throttle channel to both the 3/1 and your brushless ESC. You might be able to do it without using the built-in revo mixing but you'll have to somehow "fool" the 3/1 into arming.

-fox

PM  EMAIL  HOMEPAGE  Attn:RR  Quote
01-23-2007 04:52 AM  10 years agoPost 3
Matt Runhart

rrNovice

Kitchener, Ontario, Canada

My Posts: All  Forum  Topic

Most of the "mixing" is done via a set rate between throttle and rudder so just plug the brushless esc and your standard esc into the receiver as normal EXCEPT plug the 2 throttle channels into it with a y cable and cut the red wires on the plugs of the least powerful bec. AKA if your stock has a 1A bec(it does) and your brushless has a 1.5A bec the cut the red wires on the receiver plugs from the
3 in 1.

If you EMAIL me NOT on this thread then i will give you step by step pics later this week when I do my Third brushless highend install on a CP Pro+ / the next step up from a cp pro (IE all alum. and CF along with a 4s lipo and brushless tail and GY401 and DX7). The reason for email and not in this thread is 1) I would like to document this and make its own thread, and 2) The pic resolution on RR seems to be low and for something of this nature you would need to see individual wires. in the end - email= higher resulution and better visibility.

Post a reply stating if you'd like to see the install. if more than no-one is interested then I'll probably make the thread about it.

The Ground is Your Enemy..... Avoid it at All Costs....

PM  EMAIL  Attn:RR  Quote
01-27-2007 11:04 PM  10 years agoPost 4
cobra command

rrNovice

Syracuse, NY USA

My Posts: All  Forum  Topic

I am interested!

PM  EMAIL  Attn:RR  Quote
01-28-2007 01:24 AM  10 years agoPost 5
Micro-Maniac

rrElite Veteran

Pasco,Washington Formerly: Captain Chaos

My Posts: All  Forum  Topic

Pull the center power wire from the Brushless ESC as the the RX will be powered by both the Throttle and Rudder leads from the 3-in-1 - If you pull one of the 3-in-1 power leads then for some reason the 3-in-1 won't work as it expects detection of power through both the throttle and rudder leads.

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 621 views
Helicopter
e-
Blade
Other › blade cp brushless upgrade with a dx-6 ?
 Print TOPIC  Make Suggestion 

 4  Topic Subscribe

Monday, December 11 - 2:21 am - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online