RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 737 views POST REPLY
Helicopter
e-
Align
Other › Anti rotation bracket binding on 450 SE and SA
11-24-2006 09:42 PM  11 years agoPost 1
caseyjholmes

rrElite Veteran

Portland, Oregon

My Posts: All  Forum  Topic

Just had a pm about this.
for maximum pitch and throws, cut as shown so you don't get binding from the elevator sero and eccpm interaction. This isn't required for non 3D setups, but if you fly with max pitch anyways, might want to check it out.


cut along red lines to remove any possible linkage binding from the ele servo

PM  EMAIL  GALLERY  Attn:RR  Quote
11-25-2006 02:11 AM  11 years agoPost 2
Jason Bell

rrElite Veteran

California

My Posts: All  Forum  Topic

I was the one who discovered this, worked great! After cutting it off I had to file it a bit more for some more clearence, guess I didnt cut far enough, put that also took care ok my increased pitch when at full down elevator, and full positive pitch. cut it off,filed it and now problem gone.

Reason is because servo is stopped at the point were it hits at so the other servos move like they are told to while the elevator is trying to move but it just cant overcome plastic, o removing the plastic, rids the binding so the elevator servo can move fully.

took 5 minutes to do very simple

AMain.com
Mikado "V Team"
Xnova Motors
Optipower USA
RCProPlus

PM  EMAIL  GALLERY  Attn:RR  Quote
11-25-2006 01:58 PM  11 years agoPost 3
Andreas

rrVeteran

Sweden

My Posts: All  Forum  Topic

Thanks for the tip. I haven't noticed the binding there. Now it's cut and the servo arm moves as free as it should

Andreas

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 737 views POST REPLY
Helicopter
e-
Align
Other › Anti rotation bracket binding on 450 SE and SA
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Saturday, April 21 - 2:44 pm - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online