RunRyder RC
 2  Topic Subscribe
WATCH
 1 page 392 views
HelicopterHIROBOOther › Freya/X-Spec 60 size 90 size fan diff?
12-03-2005 11:30 PM  12 years agoPost 1
jkru

rrApprentice

Seattle, WA

My Posts: All  Forum  Topic

I have a couple freya's for parts I was trying to make a working freya out of. Is the .90 size fan the same as the .60 size fan? I am trying to slide it onto the crank but it wont. The fan from my xspec slides just fine? Could someone confirm if this is the case?

Thanks

JKru

PM  EMAIL  GALLERY  Attn:RR
12-03-2005 11:35 PM  12 years agoPost 2
Quickster

rrVeteran

Victoria, Australia

My Posts: All  Forum  Topic

I believe it should fit. Have you removed the taperd collet from the fan hub first. What make of engine is it? As i think there is some that have a different Crank.

PM  EMAIL  GALLERY  Attn:RR
12-03-2005 11:46 PM  12 years agoPost 3
jkru

rrApprentice

Seattle, WA

My Posts: All  Forum  Topic

I dont believe I have removed the "tapered collet" its a YS 91. I take it you are refering to the coper sleve that is in the fan. Should part of it be removed to fit?

THanks

JKru

PM  EMAIL  GALLERY  Attn:RR
12-03-2005 11:49 PM  12 years agoPost 4
jkru

rrApprentice

Seattle, WA

My Posts: All  Forum  Topic

Ok I think I got it. I removed the tapered collet and slid it on the shaft and then slide the fan down over top and it worked fine. Should I locktite the nut on the shaft as well instructions dont call for it?

JKru

PM  EMAIL  GALLERY  Attn:RR
12-04-2005 12:04 AM  12 years agoPost 5
Quickster

rrVeteran

Victoria, Australia

My Posts: All  Forum  Topic

I always do just for piece of mind, but only use the blue 243 so it wont be too hard to get it undone again when the time comes.

PM  EMAIL  GALLERY  Attn:RR
WATCH
 1 page 392 views
HelicopterHIROBOOther › Freya/X-Spec 60 size 90 size fan diff?
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Friday, December 15 - 6:33 am - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online