RunRyder RC
 2  Topic Subscribe
WATCH
 1 page 545 views
Helicopter
e-
Blade
Other › Tail motor wiring??
12-02-2005 04:47 AM  12 years agoPost 1
alee_6891

rrNovice

Salina, KS

My Posts: All  Forum  Topic

I recieved my blade cp about a month ago and have had no problems what so ever. Well yesterday, i was demonstrating it to a friend and tried hugging the ceiling. NOT GOOD!!! I hit the ceiling and it crashed on the floor breaking my tail boom. My question is, How do you remove the wiring out of the tail boom?? I understand that you must use some type of heat to remove the tail boom from other posts i have read, but that will do me no good with the wiring inside of it. Am i supposed to remove the wiring from the motor?? PLEASE HELP!!!

PM  EMAIL  Attn:RR  Quote
12-02-2005 05:28 AM  12 years agoPost 2
nesbocaj

rrNovice

New York

My Posts: All  Forum  Topic

De-solder the wires from the tail motor. Remove the boom. Run the wires through the new boom as you attach it to the frame. Route the wires through the tail piece as you reattach it..
Glue your new boom to the frame, glue your tail piece (while keeping it straight). Re-solder the wires to the tail motor, done.
You may find is easier to just buy a new frame with boom and tail piece, the wires come with this 'kit'.

Bob J

PM  EMAIL  Attn:RR  Quote
WATCH
 1 page 545 views
Helicopter
e-
Blade
Other › Tail motor wiring??
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Monday, December 11 - 11:31 am - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online