I'm trying to set up the tail of my Trex after a ccpm rebuild. Questions:
1. What Swash plate type should I use in the radio?
I copied from my vigor cs the type "SR-3". is this right?
2. What should I set as the "gyro sensitivity swithch"? My vigor is with the "conditional" switch. Should I copy this?
I'm trying to set up the tail. I was under the impression that I need to first set the tail up in normal mode and then flick my gyro sensitivity switch 5 or 6 times to set up a new starting point in HH. Is this right?
I first start with my gyro sensitivity switch assigned to "F". This leaves me with the following
Rate-Up AVCS- ___%
Down Norm ___%
In this set up, when my switch F is down (normal mode), I can take off and adjust the rudder trim until the tail is solid. I then land and flick the gyro switch F 5 or 6 times to reset the midpoint and leave the switch in the up or HH position. Here I get a solid red light on the gyro telling me it's in HH however, as soon as any throttle input is given, the red light flashes which tels me there is a rudder input but there is not. The heli will wag and turn nose right drasticly trying to fly in HH. If I flick the switch back to nor mode, it flys fine. I've tried different settings for the AVCS and normal all with about the same result.
I then looked at the programming in the radio for my other helis. My vigor has the gyro switch assigned to "condit" which I don't even know what that is but the Idle up swithches assign it.
I feel like I'm carrying on. Can someone post a thread to set up the tail properly with a trex and a 9C. Please also inlude what Swash type you're using. I don't have the manual for my 9C and that is the major problem I think.