RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 511 views POST REPLY
05-02-2005 10:49 PM  12 years agoPost 1
Zilly

rrVeteran

UK

My Posts: All  Forum  Topic

Another prang today with the X3d, this time the tail just let go when i was just hovering. Same damage as usual main gear and main shaft. (must get to that hold quicker)

I think this was caused by the tail drive pinion (E118) starting to turn on the end of the tail drive shaft it slipped so badly the tail could not hold and so I lost it.

I had notice it coming loose before and had already cyano'd it on. so I have re glued it and its ok now however is there a more secure way to fit this so I dont get a repeat.

The shaft does have some light groves in the end but they are very faint and not to deep. perhaps I should try to make them deeper to grip the pinion more?

z

PM  EMAIL  GALLERY  Attn:RR  Quote
05-02-2005 11:42 PM  12 years agoPost 2
Lowell Foo

rrApprentice

Vancouver, BC, Canada

My Posts: All  Forum  Topic

I use CA in that gear with good results. Try JB Weld if CA doesn't work.

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
WATCH
 1 page 511 views POST REPLY
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Tuesday, January 23 - 5:59 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online