RunRyder RC
 3  Topic Subscribe
WATCH
 1 page 531 views POST REPLY
HelicopterHIROBOOther › X-spec Asslby #18
04-03-2005 11:48 PM  13 years agoPost 1
Helodad

rrApprentice

Sunny, FLA

My Posts: All  Forum  Topic

Should adjust per inst or use my radio to make sure there is no interference between upper swash and control rods?

PM  EMAIL  GALLERY  Attn:RR  Quote
04-03-2005 11:58 PM  13 years agoPost 2
white chocolate

rrKey Veteran

Baltimore, Md.

My Posts: All  Forum  Topic

Adjust what per instructions?? Follow instructions all the way to putting avionics in. Then when doing the links use whats best to get all your right angles and level swash!

PM  EMAIL  GALLERY  Attn:RR  Quote
04-04-2005 12:27 AM  13 years agoPost 3
Helodad

rrApprentice

Sunny, FLA

My Posts: All  Forum  Topic

Its say to make the rod on the fly bar 24mm if I adjust per inst it looks like it will be below 20 is this norm whats your all fly bar control rod length?

PM  EMAIL  GALLERY  Attn:RR  Quote
04-04-2005 12:50 AM  13 years agoPost 4
I3DM

rrProfessor

Israel

My Posts: All  Forum  Topic

can you try and explain the problem better please ?

www.liorzahavi.com

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
04-04-2005 02:01 AM  13 years agoPost 5
Helodad

rrApprentice

Sunny, FLA

My Posts: All  Forum  Topic

In step 18 it says to make sure that there is no interaction between control rod and the upper swash plate. (on the left side of page) I thought you would check this until servos in place due to the throw of the servos?

PM  EMAIL  GALLERY  Attn:RR  Quote
04-04-2005 03:17 AM  13 years agoPost 6
Duracizer

rrApprentice

NC

My Posts: All  Forum  Topic

I'm at the point now where I am making up all of the control rods. I left the adjustment of the swash until I am ready to set everything up, then if it's needed I wil go back to the swash and make sure there is no interaction...

PM  EMAIL  Attn:RR  Quote
WATCH
 1 page 531 views POST REPLY
HelicopterHIROBOOther › X-spec Asslby #18
 Print TOPIC  Make Suggestion 

 3  Topic Subscribe

Friday, April 27 - 2:19 am - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online