RunRyder RC
 2  Topic Subscribe
WATCH
 1 page 553 views POST REPLY
HelicopterEngines Plugs Mufflers Fuel › Engine problems!!!!
04-03-2005 10:02 PM  13 years agoPost 1
P.J.

rrVeteran

Ireland

My Posts: All  Forum  Topic

Lads,

MY 50 ENGINE KEEPS BLOWING GLOW PLUGS.....

The engine cuts in the air and when i take out the glow plug and look at the coil its like there is a little lump of solder on it.

I can't see it been bad glow plugs cause i've tryed enya and os.
Does anyone know what my problen is??????????

P.J.

SAB Heli Division
Hyperion
Spektrum RC
Scorpion Systems
Spartan rc

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
04-03-2005 10:39 PM  13 years agoPost 2
airdodger

rrElite Veteran

Johnston USA

My Posts: All  Forum  Topic

Look at the rear bearing, easy to do, then pull the pipe and look in the exhaust and see if there are lines on the piston or if it looks dull and dry. Then if everything is ok, proceed to richen engine, your compression could be too high also, you did not say what make of engine you are running or what fuel. Chris

PM  EMAIL  GALLERY  Attn:RR  Quote
04-03-2005 11:49 PM  13 years agoPost 3
P.J.

rrVeteran

Ireland

My Posts: All  Forum  Topic

RV50 imz
20% coolpower

SAB Heli Division
Hyperion
Spektrum RC
Scorpion Systems
Spartan rc

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
04-04-2005 12:32 AM  13 years agoPost 4
Al Magaloff

rrMaster

12,199 Posts- Enough Time Wasted. See Ya!

My Posts: All  Forum  Topic

Have you adjusted the low needle at all? I found with my IMZ, the low was very lean on 30%CP.

PM  EMAIL  Attn:RR  Quote
WATCH
 1 page 553 views POST REPLY
HelicopterEngines Plugs Mufflers Fuel › Engine problems!!!!
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Monday, April 23 - 4:21 am - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online