RunRyder RC
| 3 Topic Subscribe |
WATCH |
1 page 806 views | POST REPLY |
| Scorpion Power | Scorpion Power |
|
|
| 04-02-2005 07:24 AM 13 years ago | Post 1 |
| x_Tomi_x rrApprentice TX | Hey guys, what's your two front servo linkage's length? Or normal length it should be. I would like to have a start. I'm new to 120 ccpm and I'm having a big headache trying to figure out how center the blades at 0 degrees with the servo arms pointing 90 degrees..-Tomi | ||
| |||
| 04-02-2005 10:43 AM 13 years ago | Post 2 |
| ghjr rrNovice Byram, MS | Which eCCPM mod are you using? | ||
| |||
| 04-02-2005 07:14 PM 13 years ago | Post 3 |
| x_Tomi_x rrApprentice TX | the most current one with the 2 servos in the servo tray and the elevator servo in the rear.Anyway, I got it figured out. I put my throttle stick centered, slap the pitch gauge on, and adjusted the linkages. I'm good to go now. I think I get more pitch than before with this setup. Anyway,, NOw i need to figur out how high the antirotation plate is going to be ...-Tomi | ||
| |||
| 04-02-2005 07:44 PM 13 years ago | Post 4 |
| MrMel rrProfessor Gotland | Just put on throttle hold and do a full pitch, remember to do full elev cyclic backwards.
| ||
| |||
| 04-02-2005 10:56 PM 13 years ago | Post 5 |
| x_Tomi_x rrApprentice TX | No ESC so I didn't have to worry bout that. waiting for a replacement from Castle Creations..Anyway, there's my antirotation plate. I used part of the broken stock frame and made a little mount for the plate. I screwed it down barely with the shortest screw I could find and tacked it down with CA and CA accelerator... There you go! -Tomi   | ||
| |||
WATCH |
1 page 806 views | POST REPLY |
| Scorpion Power | Scorpion Power |
|
|
| Print TOPIC | Make Suggestion |
Tuesday, April 24 - 7:28 pm - Copyright © 2000-2018 RunRyder EMAIL • Enable Cookies
