RunRyder RC
 0  Topic Subscribe
WATCH
 1 page 432 views POST REPLY
HelicopterThunder TigerOther › Raptor 90 STD build question(s)
12-11-2004 02:04 AM  13 years agoPost 1
Heli88

rrKey Veteran

Clarkston, MI

My Posts: All  Forum  Topic

When putting the lower frame assembly together, the instructions note that the lower BRG subassembly is installed upside-down.

Which way is upside-down? The bearing itself is not centered in the housing...one side of the housing has a thicker lip than the other. Does the thicker side go up or down?

Bear with me, this probably won't be the last question I have!

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
12-11-2004 02:17 AM  13 years agoPost 2
capebob

rrVeteran

Cape Coral, FL

My Posts: All  Forum  Topic

The main shaft bearing holders have one side with a raised rim around the bearing hole. Consider that the top and install the top bearing holder with the raised rim up and the lower bearing holder with the raised rim down.

Hope this helps,

Bob

Success is the ability to go from one failure to another with no loss of enthusiasm. Churchill

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
12-11-2004 03:17 AM  13 years agoPost 3
Heli88

rrKey Veteran

Clarkston, MI

My Posts: All  Forum  Topic

Yes it helps Bob. Thanks.

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
WATCH
 1 page 432 views POST REPLY
HelicopterThunder TigerOther › Raptor 90 STD build question(s)
 Print TOPIC  Make Suggestion 

 0  Topic Subscribe

Tuesday, April 24 - 11:46 am - Copyright © 2000-2018 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online