RunRyder RC
 2  Topic Subscribe
WATCH
 1 page 450 views
Scorpion Power Scorpion Power
HelicopterThunder TigerOther › ATV rates
10-24-2004 02:34 PM  13 years agoPost 1
revman

rrApprentice

Leicester UK

My Posts: All  Forum  Topic

Can any one tell me the atv rates to set the rudder channel on a 401 gyro and a 9254. If left at 100% the travel only happens in the middle of stick travel with big amounts of dead space. this is with the angle on the gyro set ok.
On a rappy 50V1

PM  EMAIL  Attn:RR  Quote
10-24-2004 02:53 PM  13 years agoPost 2
capebob

rrVeteran

Cape Coral, FL

My Posts: All  Forum  Topic

If left at 100% the travel only happens in the middle of stick travel with big amounts of dead space.
That's the way most heading hold gyros work. You set the servo throw using the limit pot on the gyro. You use the ATV to set the piro rate.

Bob

Success is the ability to go from one failure to another with no loss of enthusiasm. Churchill

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
10-24-2004 03:12 PM  13 years agoPost 3
ornatep

rrApprentice

San LUis Obispo, CA​USA

My Posts: All  Forum  Topic

on my 9z my atv rates are around 50+- we set ours up with as much atv until taill wags then back off, your servo limit is set on the amp on the limit screw adjuts it until the sliders just hit the tail case, good luck

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 450 views
Scorpion Power Scorpion Power
HelicopterThunder TigerOther › ATV rates
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Tuesday, November 21 - 12:15 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online