RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 401 views
Scorpion Power Scorpion Power
10-20-2004 05:35 AM  13 years agoPost 1
RedDirt

rrNovice

Leeds, Utah

My Posts: All  Forum  Topic

I'm setting up my new ZAP 400. I have a JR 6102 Tx and an Expert RF650 Rx. Are these the right assignments?
1-throttle, 2-aileron, 3-elevator,4-rudder, 6-collective

If nobody knows, what is the right procedure to test them one at a time?

RedDirt (Fly - Crash - Repair - Repeat)

PM  EMAIL  Attn:RR  Quote
10-20-2004 07:02 AM  13 years agoPost 2
WreckRman2

rrKey Veteran

Orlando, FL

My Posts: All  Forum  Topic

Those are correct... channel 6 might be labeled as aux channel.

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
10-21-2004 04:21 AM  13 years agoPost 3
DaBman

rrApprentice

San Diego, Ca.

My Posts: All  Forum  Topic

Red Dirt, with your servos plugged into their respective channels on your Rx when you move your elevator stick forward or aft for instance, your elevator servo should move forward or aft if it is moving forward when you pulling back(aft) then either reverse the position of your servo or use the servo reverse feature this Tx has. Do this with all of your servos and channels. This is a nice Tx, I have one, and the precise digital trim you can acheive on this Tx is phenominal. Good luck!

PM  EMAIL  Attn:RR  Quote
WATCH
 1 page 401 views
Scorpion Power Scorpion Power
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Friday, November 17 - 9:06 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online