RunRyder RC
 2  Topic Subscribe
WATCH
 1 page 801 views
Helicopter
e-
JR-Heli
Other › VE Fell off table ?????
06-01-2004 01:33 PM  13 years agoPost 1
mattdv

rrNovice

Willow Grove PA

My Posts: All  Forum  Topic

Quick question? I stupidly placed my VE in a bad spot and it fell off onto the floor from about
2 feet up and bent the flybar . I replaced the flybar and was wondering If I should replace the main shaft and spindle too . I did have a chance to hover it this morning before work and it seemed fine there was a very slight front to back wobble but I was using a 7 cell and I am sure the head speed was not high enough. If the spindle or the main shaft were slightly bent how would the helicopter react? I do not want to start replacing parts if I do not have to

Thanks
Matt

PM  EMAIL  Attn:RR  Quote
06-01-2004 06:34 PM  13 years agoPost 2
August

rrNovice

San Marcos CA

My Posts: All  Forum  Topic

You would have the wobbles or shakes. It sounds like all is well but if you are worried about them take them out and roll them on a piece of glass. Like I said it sounds like they are fine.


August

PM  EMAIL  Attn:RR  Quote
WATCH
 1 page 801 views
Helicopter
e-
JR-Heli
Other › VE Fell off table ?????
 Print TOPIC  Make Suggestion 

 2  Topic Subscribe

Tuesday, December 12 - 8:33 am - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online