RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 365 views
HelicopterRadio - Servo - Gyro - Gov - Batt › 8103 trainer system
04-30-2004 10:32 PM  13 years agoPost 1
rc30fan

rrNovice

DFW

My Posts: All  Forum  Topic

I've been teaching a friend to fly his Venture over the last few weeks. We both have the JR 8103 transmitters and the buddy system on this radio has been very helpful.
Until recently he has been flying the left stick and now that he has that under control I was planning to give him control of the right stick.
During preflight checks I noticed that the eccpm system was messed up when under control of the slave. When the master tx has control the eccpm control is normal. I checked all the settings and everything was as it should be, but whenever the slave tx has control the left servo doesnt move at all and the other servos are reversed.
I figured this must be a programming/setup problem within the slave tx but then I swapped the modules to make the slave the master and vice versa but again the exact same problem happened.

Has anyone else experienced this problem?

JR 10X, Tempest FAI, X-Cell Graphite Custom, Swift16

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 365 views
HelicopterRadio - Servo - Gyro - Gov - Batt › 8103 trainer system
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Monday, December 11 - 5:32 am - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online