RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 556 views
HelicopterBergen R/C Helicopters › Tail Gear Mesh? Gasser
04-27-2004 02:01 PM  13 years agoPost 1
loewermx

rrVeteran

Alexandria, La

My Posts: All  Forum  Topic

I am having a problem getting the tail mesh correct. Everything spins free on its own but as soon as I put the trans in place it feels like something is binding; no matter how loose the gear mesh is. Is there any trick to this?

I did notice the front of the tail gear is rubbing the lower bearing block. I did not see any way to move the gear back.

Is there any way to get a driven tail?

Also, what it the biggest blade I can run on this?

Scott

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
04-27-2004 11:08 PM  13 years agoPost 2
Malorie

rrElite Veteran

Paw squared, MI

My Posts: All  Forum  Topic

Check to see that the back set screw in the pinion gear is in the dimple in the transmission shaft.

There is an upgrade available for the driven tail.

If you have the 33" tailboom, then you can run up to 720mm main blades.

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 556 views
HelicopterBergen R/C Helicopters › Tail Gear Mesh? Gasser
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Tuesday, December 12 - 2:14 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online