RunRyder RC
 1  Topic Subscribe
WATCH
 1 page 772 views
HelicopterJR Heli Vibe 90/50, Sylphide 90, GSR260 › Decided on Vigor cs What do I need to get for 3d?
04-26-2004 02:53 PM  13 years agoPost 1
jameswill4

rrVeteran

Pineville KY

My Posts: All  Forum  Topic

Hey guys what paddles and flybar , any other upgrades needed for 3d?

PM  EMAIL  GALLERY  Attn:RR  Quote
04-26-2004 03:07 PM  13 years agoPost 2
DS 8717

rrProfessor

Here wishing i was somewhere else

My Posts: All  Forum  Topic

V paddles and stock 500mm flybar,or if you have a high pucker factor the stock flybar and KSJ paddles supplied with the kit.. DOUG

PM  EMAIL  GALLERY  Attn:RR  Quote
04-26-2004 03:24 PM  13 years agoPost 3
JRMAN

rrVeteran

Macedon, New York

My Posts: All  Forum  Topic

DOUGLAS has it right, V-paddles and the 500mm flybar. I would also think about getting to High Zoot tail pitch slider.



The less time I have the more I get done.

PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR  Quote
04-27-2004 01:45 AM  13 years agoPost 4
jameswill4

rrVeteran

Pineville KY

My Posts: All  Forum  Topic

Well I abought a used vigor on here What blades do you guys run on them? And what all should I check before I Fly in regards to a rebuild This is my first Vigor If you couldn,t tell.

PM  EMAIL  GALLERY  Attn:RR  Quote
04-27-2004 05:23 AM  13 years agoPost 5
carcrasher

rrElite Veteran

east coast

My Posts: All  Forum  Topic

how well was it taken care of? I would regrease the thrust bearings in the head and tail.

PM  EMAIL  GALLERY  Attn:RR  Quote
04-27-2004 01:17 PM  13 years agoPost 6
jameswill4

rrVeteran

Pineville KY

My Posts: All  Forum  Topic

Ok so regrease the thrust bearing anything else I have not recieved I model yet , but the pics it looked in good condition, I was't sure if a vigor needed some extra care in certain places.

PM  EMAIL  GALLERY  Attn:RR  Quote
04-27-2004 02:11 PM  13 years agoPost 7
carcrasher

rrElite Veteran

east coast

My Posts: All  Forum  Topic

What size engine are you going to run? You might want to pick up a bevel gear support forwww.rotarsoft.com or a cnc bearing block if you run 8:1 gear ratio.

PM  EMAIL  GALLERY  Attn:RR  Quote
04-27-2004 02:24 PM  13 years agoPost 8
jameswill4

rrVeteran

Pineville KY

My Posts: All  Forum  Topic

I am going to be running an os cspec p

PM  EMAIL  GALLERY  Attn:RR  Quote
WATCH
 1 page 772 views
HelicopterJR Heli Vibe 90/50, Sylphide 90, GSR260 › Decided on Vigor cs What do I need to get for 3d?
 Print TOPIC  Make Suggestion 

 1  Topic Subscribe

Monday, December 11 - 7:05 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies

Login Here
 New Subscriptions 
 Buddies Online