RunRyder RC
 3  Topic Subscribe
WATCH  1 page 63 views POST REPLY
Scorpion Power Hitec RCD
NQNA

Elite Veteran

USA

My Posts: All  Forum  Topic

I am having a problem with my Hobbywing Platinum PRO v4 60A doing the initial throttle calibration.

When the esc is plugged into power, it will not do the sequence of beeps described in the manual.

I am plugging the battery in with the throttle at full with a 0-25-50-75-100 curve as described in the instructions. I've even adjusted the throttle atv to 140% at full throttle to see if that's the problem but no luck.

I'm running a Vbar Neo system and a Spektrum 18 transmitter.

Any Ideas??

Thanks

02-10-2017 09:53 PM
PM  EMAIL  GALLERY  Attn:RR
iyoy

Senior Heliman

Bacolod City, Philippines

My Posts: All  Forum  Topic

ATV endpoint at low

Did you also set your ATV endpoint at low throttle? Also the trim? Lastly, your throttle servo direction might be reversed.

iyoy

02-11-2017 06:52 AM
PM  EMAIL  GALLERY  Attn:RR
Tyler

Elite Veteran

Chicagoland area

My Posts: All  Forum  Topic

With vbar neo, the power cycle must be almost instantaneous. You may need a helper or devise a switch to more easily and quickly cycle the power.

I struggled with this for days.

Enjoy things that money can buy IF you don't lose the things money can't buy.

02-11-2017 02:08 PM
PM  EMAIL  GALLERY  Attn:RR
NQNA

Elite Veteran

USA

My Posts: All  Forum  Topic

I found the way to calibrate the throttle travel for the ESC on the Governor basic setting II tab in the Vbar software. There is an option to select throttle servo adjustment through the collective. You get direct throttle control without the governor turned on which allowed the ESC to setup properly..

02-11-2017 11:56 PM
PM  EMAIL  GALLERY  Attn:RR
Tyler

Elite Veteran

Chicagoland area

My Posts: All  Forum  Topic

NQNA,

Congratulations on finding a solution...

I am unaware of this method you used. Would you mind sharing more detailed instructions or providing a link to information online?

Enjoy things that money can buy IF you don't lose the things money can't buy.

02-13-2017 05:05 AM
PM  EMAIL  GALLERY  Attn:RR
NQNA

Elite Veteran

USA

My Posts: All  Forum  Topic

Tyler,

Here are the pages in the Vbar software that I used to calibrate the throttle.


Starting on this page select the Vbar Electric Governor. Then hit Reset to Electric. Then hit continue.

This will bring you to this page.

You then select the Throttle servo adjustment box and then unplug the ESC from the battery. Place the throttle/collective stick on the transmitter to the full power/collective position and then plug the battery into the ESC. You then will hear the appropriate tones from the ESC and you will be able to program.

If you don't want to use the Vbar software Governor, you can go back to the first governor page and select External ESC Gov.

Hopefully this helps!

02-13-2017 05:58 PM
PM  EMAIL  GALLERY  Attn:RR
WATCH  1 page 63 views POST REPLY
ProModeler Scorpion Power
 Print TOPIC Advertisers 

 3  Topic Subscribe

Sunday, February 26 - 5:05 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies