RunRyder RC
 1  Topic Subscribe
WATCH  1 page 331 views POST REPLY
ProModeler Scorpion Power
Kiba

Senior Heliman

CA

My Posts: All  Forum  Topic

My Classified Activity
My Classified Feedback
Add Classified Feedback

SOLD 1/2

Swapping my helis over to Axons and Jeti Rex 7 receivers, so have some parts available...

I have one Bavarian Demon 3SX FBL unit for sale (has rescue & horizon mode.) This is the gray HC3SX labeled unit, I purchased them just before Captron switched over to Bavarian Demon labeling. No crashes on the unit, it flies perfect! Was just flying it two weekends ago. Original metal box, RX cable loom, USB programming dongle, 1x thick mounting tape and 3x fresh pieces of Acro mounting tape included.

Asking $155 shipped & insured, please PM for contact. Thanks!

12-08-2016 03:51 PM
PM  EMAIL  Attn:RR
BrooklynJim

Heliman

Starlight, PA

My Posts: All  Forum  Topic

My Classified Activity
My Classified Feedback
Add Classified Feedback

whats the serial number of this unit?

12-10-2016 04:24 AM
PM  EMAIL  GALLERY  Attn:RR
Kiba

Senior Heliman

CA

My Posts: All  Forum  Topic

My Classified Activity
My Classified Feedback
Add Classified Feedback

whats the serial number of this unit?
066-057-114

I see you commented in another thread about 3X / 3SX use with turbines... while this unit has the older sensors that are potentially susceptible to turbine acoustics this particular unit came out of my turbine heli where it served 60 trouble free hours even without the foam acoustic hood.

That being said, while I'd have no problems running this unit in a pod & boom turbine heli like my Magnum 44 I wouldn't recommend putting it in a full scale fuselage turbine without the foam acoustic hood if the turbine and FBL controller are sharing space inside the fuselage... just in case. I just happen to have one of the foam acoustic hoods I could include.

12-10-2016 05:36 AM
PM  EMAIL  Attn:RR
ssrobzoom

Key Veteran

Tn

My Posts: All  Forum  Topic

My Classified Activity
My Classified Feedback
Add Classified Feedback

So Whats the deal with the serial numbers? Have they changed the sensors?

12-13-2016 03:47 PM
PM  EMAIL  GALLERY  Attn:RR
BrooklynJim

Heliman

Starlight, PA

My Posts: All  Forum  Topic

My Classified Activity
My Classified Feedback
Add Classified Feedback

yah, after sequence 70 ******** the sensors have been updated and arent affected by ultrasonics from the turbine,

pre 70 serial numbers have to use the ultrasonic hood/pocket thats available from BD, but.. would you take the chance on a $10k plus scale helicopter?

12-13-2016 08:05 PM
PM  EMAIL  GALLERY  Attn:RR
WATCH  1 page 331 views POST REPLY
Hitec RCD ProModeler
 Print TOPIC Advertisers 

 1  Topic Subscribe

• CLASSIFIEDS HELP-FAQ Buyer beware! RunRyder cannot vouch for any seller's or buyer's credibility and will not accept responsibility for any transactions resulting from the use of this site.

Monday, February 27 - 1:37 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies