RunRyder RC
 2  Topic Subscribe
WATCH  1 page 173 views POST REPLY
ProModeler Scorpion Power
Rudy43

Heliman

Splendora, Texas-USA

My Posts: All  Forum  Topic

This is only my second build. I have installed the main shaft with the spacer on the top bearing block and main gear in and I've noticed that I still have play when I lift up on the head block.
I do have an extra spacer, but it does not show two being installed. What can I do to fix this?

I did have this same problem when I built an NX4 and found out that I had a bearing block upside down. But these look identical.

Thanks

10-17-2016 04:08 PM
PM  EMAIL  GALLERY  Attn:RR
nynextel88

Heliman

longisland, NY

My Posts: All  Forum  Topic

You should be able to find the correct washer to use in the spare parts bag, but if not no harm in using two if necessary. Just make sure it isn't too tight putting the bolt through gears.

Team Align (Enterprise Hobby)
Thunder Power RC

10-18-2016 04:22 AM
PM  EMAIL  GALLERY  Attn:RR
WATCH  1 page 173 views POST REPLY
AlignRC Thunder Power RC
 Print TOPIC Advertisers 

 2  Topic Subscribe

Saturday, December 10 - 12:40 pm - Copyright © 2000-2016 RunRyder   EMAILEnable Cookies