RunRyder RC
 1  Topic Subscribe
WATCH  1 page 110 views POST REPLY
Thunder Power RC ProModeler
mtickel25

Heliman

columbia, s.c. - u.s.a.

My Posts: All  Forum  Topic

Hello....I am running this on the TSA 700E and I had the Savox BSM-5065-530KV motor on it before working with no problem. Just mounted this motor tonight and hooked up the leads to the 120HV Talon esc changed a few settings so the governor knows the specs of the motor (I'm using the esc governor). I go to test the motor to see if it's spinning the right direction and nothing happens.....thottle hold is not on, all of the stick movements seem to be working fine in the MSH Brain software. I'm thinking I have a dud motor. Your thoughts?

10-04-2016 01:48 AM
PM  EMAIL  GALLERY  Attn:RR
mtickel25

Heliman

columbia, s.c. - u.s.a.

My Posts: All  Forum  Topic

Old motor not working either.....

Well there seems to be a problem within the electronics...I would assume the ESC..... I put my old motor in and it doesn't want to spool up either. The only thing that was done is swapping motors, setting the PWM to 8kHz and dropping the KV to 520. I did mistakenly plug the S.bus wire in the wrong way into the receiver.....but the way it was plugged in was all on ground no power so I don't see it shorting anything out. Any help is appreciated!

10-04-2016 12:08 PM
PM  EMAIL  GALLERY  Attn:RR
mtickel25

Heliman

columbia, s.c. - u.s.a.

My Posts: All  Forum  Topic

also when powering the heli up I noticed the esc only counting off 11 cells and quits with no tones after....and a continuous red led blinking.

10-04-2016 12:24 PM
PM  EMAIL  GALLERY  Attn:RR
mtickel25

Heliman

columbia, s.c. - u.s.a.

My Posts: All  Forum  Topic

figured the problem out in this thread..... http://rc.runryder.com/helicopter/t...1/?p=6616216#RR

10-05-2016 11:46 AM
PM  EMAIL  GALLERY  Attn:RR
WATCH  1 page 110 views POST REPLY
Scorpion Power AlignRC
 Print TOPIC Advertisers 

 1  Topic Subscribe

Tuesday, December 6 - 10:13 am - Copyright © 2000-2016 RunRyder   EMAILEnable Cookies