RunRyder RC
 2  Topic Subscribe
WATCH  1 page 217 views POST REPLY
Thunder Power RC ProModeler
wanman

Heliman

Miami FL

My Posts: All  Forum  Topic

I have a Spektrum DX 18 combined with VBar, I can not change the tail function from hold to normal directly from swithc of the TX.
Can anyone tell me what I make wrong or missing?
On the TX, I can change the function and in the computer Vstabi 5.3 show that change, but the servo function remains the same. Also I can not change the sensitivity from TX, it change only from the computer.
Thank you for help and suggestions.
Wan

09-16-2016 04:12 PM
PM  EMAIL  GALLERY  Attn:RR
Slowpoke

Key Veteran

Dublin, OH

My Posts: All  Forum  Topic

Wan,

If I'm understanding your question correctly, there are 2 ways to do this.

The first is to enable Bank Switching on the main VBar screen. On the far right side of the screen, pull the dropdown box labeled "Active Bank Selection" and select Bank 0/1/2/3.

Now, copy your Active bank into the remaining banks. Then, change the gyro gain setting each of the other banks to a different setting.

Such as:

Bank 0: Gyro Gain 60
Bank 1: Gyro Gain 65
Bank 2: Gyro Gain 70

Now, by using the switch that controls the GEAR channel, selecting another bank will change the Gyr Gain. You can switch banks in flight to immediately see the effect.

Second way is to select "Aux Gyro Gain" in the drop down, and use the values in the Aux channel to set the gain from the radio.

Is that what you needed?

Slowpoke

09-16-2016 04:30 PM
PM  EMAIL  GALLERY  Attn:RR
Qrrambero

Key Veteran

San Francisco / Bay Area

My Posts: All  Forum  Topic

Are you talking about the regular V-bar or the Neo ?

Ae

09-17-2016 05:15 PM
PM  EMAIL  GALLERY  Attn:RR
WATCH  1 page 217 views POST REPLY
Scorpion Power AlignRC
 Print TOPIC Advertisers 

 2  Topic Subscribe

Friday, December 9 - 7:13 pm - Copyright © 2000-2016 RunRyder   EMAILEnable Cookies