RunRyder RC
 0  Topic Subscribe
WATCH  1 page 85 views POST REPLY
Hitec RCD ProModeler

Senior Heliman

Kent, WA

My Posts: All  Forum  Topic

My Classified Activity
My Classified Feedback
Add Classified Feedback

selling my DT, has about 10 flights on it. I was not feeling it with this model. It had power out hard plunk down. It cracked one of the mid frame carbon plates. Also 2 of the frame blocks stripped out. Those were replaced with 3d printed versions. Canopy has been cut up a bit and massaged so use protos magnetic canopy mounts

I would assume if you're looking at this ad you're aware of the fact that DT helis are discontinued.

volante airframe
spare tail boom
stock DT motor
1 set of DT 520 blades
1 set of rotorstart 520 blades
1 set of Zeal 92mm tail blades
1 set of unused stock tail blades
4 battery plates(little holes drilled in them for a spacer i was using for the battery)
spare tail shaft.
all bearing were changed out from stock bearings.
DT hat!!!

09-16-2016 05:29 AM
WATCH  1 page 85 views POST REPLY
Scorpion Power Hitec RCD
 Print TOPIC Advertisers 

 0  Topic Subscribe

• CLASSIFIEDS HELP-FAQ Buyer beware! RunRyder cannot vouch for any seller's or buyer's credibility and will not accept responsibility for any transactions resulting from the use of this site.

Saturday, February 25 - 12:01 am - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies