RunRyder RC
 4  Topic Subscribe
WATCH  1 page 306 views POST REPLY
AlignRC Thunder Power RC
alexz

Senior Heliman

shakopee mn usa

My Posts: All  Forum  Topic

I need some help . I'm trying to set up a gpro with it. It's going to be in a trex 450l dominator. For tx and rx I'm using a dsm2 module with a dmx satellite plugged into the gpro . Right now I have successfully bound the receiver to the module . At least the lights appeared to suggest that . When I try to move any of the servos . It appears there is no communication between the transmitter gpro to the servos. In the set up menu in gpros configurator . I can only level the swash . When I try to set the end points / trim I have no respoce . Also the light on the gpro is red not green. So I'm assuming that I do not have my Taranis set up accordingly.

08-09-2016 10:22 PM
PM  EMAIL  GALLERY  Attn:RR
KJH

Senior Heliman

Interlochen, MI

My Posts: All  Forum  Topic

I'm not familiar with the Gpro. I have successfully setup a Microbeast Plus with a FrSky X4R-SB receiver via SBus on a Trex 450Pro DFC. What DSM2 module is in your X9D? Do you have a receiver to try in place of the satellite?

-Kevin

08-10-2016 02:09 AM
PM  EMAIL  GALLERY  Attn:RR
dkshema

rrMaster

Cedar Rapids, IA

My Posts: All  Forum  Topic

If the channel sliders in the first menu aren't doing anything when you move the sticks, the RX most likely isn't seeing your TX.

With your setup, you will want to bind as a DSM2 system, not DSMx.

The GPRO light is red because there is no signal from the TX to tell the GPro to operate the tail gyro in Heading Hold mode.

You also need to have your TX set up for single servo per channel (normal). At least you're not going to have to fight your Taranis TX to figure out how to set it up for CCPM mode operation. The GPro will handle that as you are able to set it up.

-----
Dave

* Making the World Better -- One Helicopter at a time! *

Team Heliproz

08-10-2016 02:39 AM
PM  EMAIL  GALLERY  Attn:RR
dkshema

rrMaster

Cedar Rapids, IA

My Posts: All  Forum  Topic

Which transmitter DSM2 module are you using?

Also, with a single satellite, try plugging it into the other port on the GPro and binding again.

-----
Dave

* Making the World Better -- One Helicopter at a time! *

Team Heliproz

08-12-2016 05:49 AM
PM  EMAIL  GALLERY  Attn:RR
chicagoslick

Senior Heliman

Indiana, USA

My Posts: All  Forum  Topic

Go to Youtube and look up "painless360". He goes through setup of the Tyrannis extensively. He relates it to quadcopters mainly, but the principles are the same...

Chicagoslick

08-12-2016 01:17 PM
PM  EMAIL  Attn:RR
WATCH  1 page 306 views POST REPLY
ProModeler Scorpion Power
 Print TOPIC Advertisers 

 4  Topic Subscribe

Thursday, December 8 - 2:03 am - Copyright © 2000-2016 RunRyder   EMAILEnable Cookies