RunRyder RC
 1  Topic Subscribe
WATCH  1 page 276 views POST REPLY
ProModeler Scorpion Power


San Antonio, TX

My Posts: All  Forum  Topic

I'm setting up a new Hirobo Shuttle and I'm unsure about the gyro/servo combination or if I'm doing something wrong on the gyro.

Also my radio is a Hitec Eclipse 7 Pro.

When I switch on the receiver system the gyro does it's initialization, blinks green, and then twitches the rudder servo to confirm that it's working. After that the LED is off and and the tail servo does not react when I rotate the heli by hand. Gain is default in the radio at 50% and I have the gyro gain/limit switch set at 50%. It's been years since I've set up a heli but I'm diligent with the instructions. I'm just not sure what I'm doing wrong

Thanks in advance!

08-06-2016 04:34 PM


Richmond, VA, USA

My Posts: All  Forum  Topic

No light and no compensation response to model movement suggest no gain.

For now pull the remote gain lead from the receiver and see if responds to the gain setting from the trimmer pot on the gyro.

Ben Minor

Team Synergy Team Futaba Team Kontronik USA
Progressive RC

08-06-2016 07:17 PM
WATCH  1 page 276 views POST REPLY
Hitec RCD ProModeler
 Print TOPIC Advertisers 

 1  Topic Subscribe

Saturday, February 25 - 6:06 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies