RunRyder RC
 3  Topic Subscribe
WATCH  1 page 304 views POST REPLY
AlignRC Thunder Power RC
racingrandy

Senior Heliman

Merritt Island FL

My Posts: All  Forum  Topic

I noticed something I have normal in AVCS and Idle up 1 2 in AVCS and it has 2.0. In normal the swash plate doesn't drift but in 1 and 2 it does and on my other 750"s it doesn't drift at all and this is just sitting on the bench not moving the radio is a Futaba T14SG I'm thinking this 750 is bad or not have anyone else had this problem or I just got something F" up

07-30-2016 12:44 PM
PM  EMAIL  Attn:RR
Dr.Ben

rrMaster

Richmond, VA, USA

My Posts: All  Forum  Topic

Are you in F3C mode? There is no normal/rate mode in 3D mode v2.0 firmware.

Ben Minor

Team Synergy Team Futaba Team Kontronik USA
Progressive RC

07-30-2016 01:54 PM
PM  EMAIL  GALLERY  Attn:RR
racingrandy

Senior Heliman

Merritt Island FL

My Posts: All  Forum  Topic

yes it's in F3C

07-30-2016 01:59 PM
PM  EMAIL  Attn:RR
racingrandy

Senior Heliman

Merritt Island FL

My Posts: All  Forum  Topic

okay I was setting this up for a buddy and I guess I should have check ever setting there sub trim set in the radio so I set them to 0 and ever thing is good

07-30-2016 03:33 PM
PM  EMAIL  Attn:RR
Dr.Ben

rrMaster

Richmond, VA, USA

My Posts: All  Forum  Topic

That will cause it every time.

Ben Minor

Team Synergy Team Futaba Team Kontronik USA
Progressive RC

07-30-2016 04:16 PM
PM  EMAIL  GALLERY  Attn:RR
carcrasher

Elite Veteran

east coast

My Posts: All  Forum  Topic

So I don't need to do a trim set-up in v2.0 anymore? I haven't done the update yet.

08-01-2016 02:51 PM
PM  EMAIL  GALLERY  Attn:RR
Knud Pedersen

Key Veteran

Denmark - Europe

My Posts: All  Forum  Topic

With V2 in 3D mode you can only do the trim setup for the tail.

In V2 F3C mode its like in v1.4.

ChopperKnud
Team Miniature Aircraft
ThePitchbrothers

08-01-2016 03:41 PM
PM  EMAIL  GALLERY  Attn:RR
WATCH  1 page 304 views POST REPLY
ProModeler Scorpion Power
 Print TOPIC Advertisers 

 3  Topic Subscribe

Monday, December 5 - 10:32 am - Copyright © 2000-2016 RunRyder   EMAILEnable Cookies