RunRyder RC
 3  Topic Subscribe
WATCH  1 page 242 views POST REPLY
ProModeler Scorpion Power
stevendavis

Senior Heliman

Ashton, Id

My Posts: All  Forum  Topic

I'm re-setting up my 300CFX and once I have the swash leveled and go full pitch, the aileron servo is traveling slightly farther causing my swash to become unlevel at full travel. Can I go into endpoints and adjust it? Or do I leave it alone? Thanks

MCP X Brushless, Blade 300CFX,Trex 600 ESP 3GX, KDE FBL Head, Trex 600N LE, Trex 700N LE 3GX

07-25-2016 05:47 PM
PM  EMAIL  GALLERY  Attn:RR
Richardmid1

rrProfessor

Leeds, England

My Posts: All  Forum  Topic

Are all servo arms at 90 at mid stick? If so I would just leave it unless it's a mile out in which case it will be a faulty servo.

60% of the time, it works every time!

07-26-2016 02:18 PM
PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR
stevendavis

Senior Heliman

Ashton, Id

My Posts: All  Forum  Topic

Yep,
I set up step G and all servos were at 90*, then I leveled the swash with the linkage arms. The servos are Hitec 5065's. It seems to be flying fine without adjusting it so far.

MCP X Brushless, Blade 300CFX,Trex 600 ESP 3GX, KDE FBL Head, Trex 600N LE, Trex 700N LE 3GX

07-26-2016 05:06 PM
PM  EMAIL  GALLERY  Attn:RR
Richardmid1

rrProfessor

Leeds, England

My Posts: All  Forum  Topic

You could try going in a hole on the servo arms. Are you getting the blue light at 6 degrees cyclic in step J?

60% of the time, it works every time!

07-27-2016 02:14 PM
PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR
stevendavis

Senior Heliman

Ashton, Id

My Posts: All  Forum  Topic

Yep,
I'm getting the blue light at 6*. Every thing works good, the aileron servo just moves up more than the rest. I can fix it with end point adjust, I just don't know if I should.

MCP X Brushless, Blade 300CFX,Trex 600 ESP 3GX, KDE FBL Head, Trex 600N LE, Trex 700N LE 3GX

07-27-2016 02:52 PM
PM  EMAIL  GALLERY  Attn:RR
Richardmid1

rrProfessor

Leeds, England

My Posts: All  Forum  Topic

I personally wouldn't as the BeastX will compensate for any unwanted tilt anyway.

60% of the time, it works every time!

07-28-2016 03:27 PM
PM  EMAIL  HOMEPAGE  GALLERY  Attn:RR
WATCH  1 page 242 views POST REPLY
AlignRC Thunder Power RC
 Print TOPIC Advertisers 

 3  Topic Subscribe

Friday, December 2 - 5:54 pm - Copyright © 2000-2016 RunRyder   EMAILEnable Cookies