RunRyder RC
 0  Topic Subscribe
WATCH  1 page 178 views POST REPLY
AlignRC Thunder Power RC
Doug

Elite Veteran

Port Saint Luice Florida....

My Posts: All  Forum  Topic

I have several Quads all running the Naz32 and handle correctly. I recently purchased a Terot 130, when flying in "Manual" it flys great and is easy to control. However, when in "Horizon" or"Angle" mode it has a heavy nose down bias which make it hard to control, the CG is dead on and I know that Transmitter "trim" is inefective. What adjustment in CleanFlight addresses this issue?

First member of Member of Bearings Anonymous

07-13-2016 12:25 PM
PM  EMAIL  GALLERY  Attn:RR
Doug

Elite Veteran

Port Saint Luice Florida....

My Posts: All  Forum  Topic

Solution

Well, with a little reading, I found the answer on the Open TX University

in the section on manual trimming of the Accelerameters (ACC calibration)

It worked as advertised. The only thing it did not mention is you must wait for the controller to "beep" on each motion of the stick. it took about 25 "beeps" on pitch and about 12 beeps on roll to get it to stay level (in my office

First member of Member of Bearings Anonymous

07-13-2016 02:33 PM
PM  EMAIL  GALLERY  Attn:RR
WATCH  1 page 178 views POST REPLY
ProModeler Scorpion Power
 Print TOPIC Advertisers 

 0  Topic Subscribe

Monday, December 5 - 12:27 am - Copyright © 2000-2016 RunRyder   EMAILEnable Cookies