RunRyder RC
 10  Topic Subscribe
WATCH  3 pages [ <<    <     1      2     ( 3 )    >    >> ] 5530 views POST REPLY
Scorpion Power Hitec RCD
ICUR1-2

Elite Veteran

Ottawa, Ontario

My Posts: All  Forum  Topic

read my other post . GL and have fun

spending time, paying attention

01-11-2017 01:05 AM
PM  EMAIL  GALLERY  Attn:RR
iyoy

Senior Heliman

Bacolod City, Philippines

My Posts: All  Forum  Topic

No test flight yet

It's raining!

Watch at YouTube

iyoy

01-11-2017 02:33 AM
PM  EMAIL  GALLERY  Attn:RR
ICUR1-2

Elite Veteran

Ottawa, Ontario

My Posts: All  Forum  Topic

you should really move those wires away from the motor Last warning

spending time, paying attention

01-11-2017 02:35 AM
PM  EMAIL  GALLERY  Attn:RR
iyoy

Senior Heliman

Bacolod City, Philippines

My Posts: All  Forum  Topic

ICUR1-2

Hi,

Sorry for my stuborness and thanks for your concern. Yes I will heed your advice and post a pic of my solution. Just to clarify your concern, is it about the possibility of the wires getting mechanical interference from the revolving motor (getting chewed up and pulled out of their sockets) or electronic interference from the current? Either way, I will strive to correct my misdoing. Thanks!

iyoy

01-21-2017 09:09 AM
PM  EMAIL  GALLERY  Attn:RR
ICUR1-2

Elite Veteran

Ottawa, Ontario

My Posts: All  Forum  Topic

the magnets of the motor spinning at high speed could potentially cause interference or even melt them.

there are a few videos on youtube where magnets spinning at high speed can melt steel.

either way strive to keep the motor, esc wires away from the RX and servo wires to avoid problems

spending time, paying attention

01-21-2017 11:39 AM
PM  EMAIL  GALLERY  Attn:RR
iyoy

Senior Heliman

Bacolod City, Philippines

My Posts: All  Forum  Topic

Wires

Copy that. Back to work on the wire routing!

iyoy

01-21-2017 11:54 AM
PM  EMAIL  GALLERY  Attn:RR
WATCH  3 pages [ <<    <     1      2     ( 3 )    >    >> ] 5530 views POST REPLY
ProModeler Scorpion Power
 Print TOPIC Advertisers 

 10  Topic Subscribe

Saturday, February 25 - 8:22 pm - Copyright © 2000-2017 RunRyder   EMAILEnable Cookies