Just trying to figure out what setups everyone is using and what's working well in your fusion 50s

Im running Futaba BLS 451's on cyclic and BLS 251 on the tail...very nice to say the least

Guess that depends on what voltage you plan to run your servos at. I'm using JR 8717's and Outrage 9088 tail because I had them.If I was buying I would be getting the Fubata BLS servos ,them center best and have the least center play .

Sponsored by Visa

ya what he said ^^^^

So everyone seems to like Futaba. I have mine set up with align 610s cause I had them, but they just don't give me that ballistic response I was looking for.

Outrage Torq's work good for me.

Mark

my 610' have been great. again like you i just had them. they seem to be great so far but this heli is really responsive and i might need a little faster servos. im getting a wobble on direction transitions while doing slowed down rainbows.

610's here too. Best bang for the buck.

-Jeff T.

Spence46 how much use have you had out of your torq's. Im going between those and the futaba hv's. Have you had any crashes with them and how many flights have you booked on them.

Outrage Torqs. Get the 91 series version servos. not the 90 series.

I run mine with 610s just fine, no problems, but thats also because i had them around.

Outrage Fusion 50, Gaui X7, ElyQ Vision 50E

Hey helinut, I have about 30 flights on em and no crashes. These are my first HV servos so I really don't have anything to gauge them against. I am running them at 8v and they seem great to me.

Mark

I have some Futaba BLS 253 for sale that are perfect cyclic servos for your fusion, shameless plug but hey these are a great deal!

http://rc.runryder.com/helicopter/t685966p1/

...Once upon a time there were Nitros, flybars and frequency pins...

Servos

I am putting one together, now . Went with the torq 91 series for cyclics and tail, but my tail servo was on backorder . I ordered a Savox High speed coreless until my Torq tail servo comes in.

Ken

"610s, Best Bang for the buck"

+1

Futaba

Helinut did you get the Futaba? I just pulled the trigger and pressing the confirm button on PP sucked, I hope they are worth it.

I have a 3D heli, I don't understand why it doesn't do 3D

Love my Fusion.
Im running the following:
The outrage motor for it,560 kv
Hyperion hv servos all the way around 7.5 volts
CC Bec Pro 2
Ice 80 hv2,1900,2000,2300 head speed
Beastx FBL unit
Sky lipo 3300 25c,7 min time,Im not 3der yet,just sport
Maverick 600mm fbl,havent tried 620 yet but I will. I really love the heli,a lot better than my old Trex's.

If you aren't crashin', you aren't flyin!! USN Ret.

JR 8917's on cyclic, 8900G on rudder.

KBDD Team Pilot/Team Compass/nankinhobby.com Gens Ace