Damnit Mike every time I see you are the last poster in a whiplash topic I want to scroll down and see "KITS ARE SHIPPING!" I better order one of your t-shirts now because I hate you more and more every post :P. One of these days you will be my best friend again, just need to see that shipping notice.

Fly it like you stole it. -Team Heliproz- -Morgan Fuel-

Check out www.Mike-3D.com
EPIC Helicopters

Outrage cyclic and Tail servo.
Futaba BLS451 on throttle.
Skookum 720.
YS120 with Funtech Pipe.
Spin FBL main and tail blades.
Coolpower 15% fuel
Entire set up on a 3800 MAH Life pack

Lots of fun.

here is my setup....
i pre-order the whippy gasser FBL

flying with the JR X9303
ALL MY SETUP WILL RUN OFF A 7.4V 2S LIPO 5000mah

1x AR9000
1X FUTABA SBE-1 SBUS ENCORDER.
1X FUTABA CGY 750
3X JR DS8917HV 7.4V
1X BLS 256 HV
1X HITEC TH SERVO STEP DOWN 5.8V
710MM MAVRIKK G5 PRO FLYBARLESS VST
105MM CARBON TAIL ROTOR BLADES
1x stator gator
1x zenoah g290rc
1x hatori sb-12
and alot of anodized washer. blue color....

i might get a custom canopy but right now i just want my heli in the air....

HERE ARE SOME PICS

RELEASE THE WHIP OUT OF THE BOX

What is the exact price tag of this model

"I just don't Listen" "

Which model? Nitro or gasser? Fb or fbl?

Fly barred gasser

"I just don't Listen" "

go flybarredless gasser. im still waiting for this model, but i had to buy the fbl electric model.....there very nice helis.

MA XCELL PRO2K: MA XCELL WHIPLASH FBL E:
Trex 700 Pro N: Trex 600 Pro N: Trex 550E: Trex 500E:

FBL Gasser Setup - Ordered Model via Heliproz on 3/9/12

My setup includes the following:
 
- HiTec Aurora 9 (9 channel) TX (w/ built in Rcv'r pack voltage telemetry)
- HiTec Optima 9 (9 channel) Rx
- HiTec Telemetry Station (includes up to 4 engine and exhaust temp sensors, GPS, and additional optical rotor RPM tracking in addition to CGY750/Stator Gator (prob won't use it though)).
- CGY750 FBL Controller (w/ SBE-1 PWM Encoder)
- PowereEdge 3000 mAh LiFePo receiver pack
- Fromeco Arizona Regulator (w/pin flag switch)
- Stator Gator (with voltage jumper)
- JR DS8717 - Cyclic Servo Set (3)
- JR PS8900G - To Be Used As The Throttle Servo
- JR PSMP80G - Tail Servo
- TRM Power 270TT Engine
- Century Torpedo V5 Muffler
- RCBooya Rear Canopy Mounts
- Neodymium Rare Earth Magnets (DH250D-FT-NI) from "Amazing Magnets .com" for Quick Release front Canopy Mounts
- Miniature Aircraft Air Filter w/ Carbon Fiber Housing
- Silver ADA Racing Cover (to go in place of pull starter)
- Mavrikk G5 Pro 690mm FBL CF Main Blades
- Radix 105mm CF Tail Blades
- All Additional Fittings For The Carey Shurley Fuel Tank Setup
- Jersey Modeler Fuel Feed Can Setup

I think that's everything?!?!
 
All received and in my Whiplash G build box... Eager to put it all in my model!

- Josh

For all you guys waiting for a FBL Whiplash; just saw that Hobby Hut has them in stock now.

Hope this helps someone..

most off us are waiting on the gassser version not the nitro one...
but yes they do have a nitro in stock

MA XCELL PRO2K: MA XCELL WHIPLASH FBL E:
Trex 700 Pro N: Trex 600 Pro N: Trex 550E: Trex 500E:

dissapointed ,waited a long time and finally bought a rave,no regrets,also $1000 for a kit is to much .gonna wait see if price comes down

Nitros have been shipping for 3-4 weeks now.

Gassers are expected to begin shipping in roughly 4 weeks.

Thanks for your patience.

Miniature Aircraft USA

Gassers are expected to begin shipping in roughly 4 weeks

or maybe less?

"Need More Parts"

What version FBL or old school?

Agree with Indy... Hopefully less.

Either way - don't want anything else. I'm waiting for a WG!!!!!

when running a life 6.6v battery unregulated with outrage hv servos beastx fbl, how long will a 2100 mah last? will I get 5-10 minute flights out of one charge? or should I buy two of these...

"Need More Parts"

I'm seeing about 400-450mah per 10 minute flight

If you're not flying a gasoline helicopter
You're paying 10 times too much for fuel!!

Hey guys whos going to have a Gasser I can preorder?

heliproz

"Need More Parts"