Topic Subscribe
WATCH  1 page1711 viewsPOST REPLY
Mikado . Futaba-RC . HeliProz
. .

Flybarless Rotor Head Systems

 >

BeastX
Factory reset
seldred

Veteran

Birmingham, AL

I looked through the book and unless I missed something, I can't seem to find how to reset the beast to factory settings. Does anyone know how to do this?

08-04-2011 Over year old.
blackbird

Veteran

thessaloniki-Greece

Hold down button until you get a solid light, let go then hold the button down for 10 secs or so, when you see all the leds do the quick cycle, you are reset.

08-04-2011 Over year old.
nickwap

Veteran

North East England

From the Manual page 33

Factory Reset:
To reset the MICROBEAST to factory settings, you can, at any setup menu point, push down the button for at
least 10 seconds until the LEDs A - N and J quickly blink one after the other to confirm the reset.
Please note that any previously configuration is deleted now. Do not attempt to fly the helicopter without
doing the complete setup procedure again otherwise you will crash your helicopter. Please note also
that all servo settings are lost, therefore you should unplug the servos and remove the servo horns before resetting
the MICROBEAST.
The receiver type settings (see Section 4) are not affected by the reset!
Conversely, if you change any settings in receiver type, the setup menu or parameter menu are not affected.
However, you have to redo the receiver-specific settings (channel assignment and fail-safe, see sections 4.2 to
4.4).

Nick

"Give me another one, this one's broke!"

08-04-2011 Over year old.
HOMEPAGE  
nickwap

Veteran

North East England

Damm too slow !

"Give me another one, this one's broke!"

08-04-2011 Over year old.
HOMEPAGE  
seldred

Veteran

Birmingham, AL

Thanks for the help, just missed the section when reading it!

08-04-2011 Over year old.
WATCH  1 page1711 viewsPOST REPLY
Boca Bearings . Encore RC . ExperienceRC
. .

Flybarless Rotor Head Systems

 >

BeastX
Factory reset
 Print TOPIC Advertisers 

Topic Subscribe

Saturday, October 25 - 4:27 am - Copyright © 2000-2014 RunRyder   EMAILEnable Cookies