| Topic Subscribe |
| WATCH | 1 page | 1104 views | POST REPLY |
| Rev.Co | . | ReadyHeli | . | Heli-Max |
|
. | 
|
. | 
|
 Henseleit 3DNT - Rocket - 3DMP>3D-NT Throttle linkage set up - help required. |
| MattHarper Senior Heliman | I've searched RR to no avail. Can anyone help me out with where to set the position of the bell crank on the Lotterle carb. The 3D-NT manual references out to the carb manual which unfortunately I don't have. I'm struggling also with the position of the throttle servo arm. Should the servo arm point directly to the bell crank at low stick postion ? Any ideas, measurements or photos would be greatly appreciated.Matthew | ||
| 08-03-2011 Over year old. |
| cudaboy_71 Elite Veteran | i don't have a lotterle manual either. maybe this helps:
Crank w/ trim down 
Horn w/ trim down 
Crank w/ trim up 
Horn w/ trim up 
Crank w/ Throttle full 
Hor w/ Throttle fullplus, a movie: if it ain't broke…break it. | ||
| 08-03-2011 Over year old. |
|
| MattHarper Senior Heliman | Thanks cudaboy_71, that's a great help. Thanks for taking time out to help, you are a very kind man.Kindest regardsMatthew | ||
| 08-03-2011 Over year old. |
| cudaboy_71 Elite Veteran | you're welcome. good luck.if it ain't broke…break it. | ||
| 08-04-2011 Over year old. |
|
| WATCH | 1 page | 1104 views | POST REPLY |
| Miniature Aircraft USA | . | Thunder Power RC | . | Mikado Modellhubschrauber |
|
. | 
|
. | 
|
Henseleit 3DNT - Rocket - 3DMP>3D-NT Throttle linkage set up - help required. |
| Print TOPIC | Advertisers |
Thursday, May 23 - 5:01 am - Copyright © 2000 - 2013 runryder.com | email | runryder needs cookie