RR Rated M For Mature
HOME   rrTV-PHOTO   GALLERIES   MY GALLERY   HELP-FAQ
myHOME PM pmRR MEMBERS 679 ONLINE 18 EVENTS SEARCH REGISTER  START HERE
 
1 page550 viewsPOST REPLY
MTA Hobbies . Model Rectifier Corp . ReadyHeli

.
.
Main Discussion > Could this be my problem?
 
 
Vitya
Veteran
Location: North York, Ontario

My Posts This: Topic  Forum		I have noticed that on my raptor 30 i can move the start shaft up and down. Could this have been causing my problem mentioned in an earlier post?
http://www.runryder.com/showtopic.htm?s=&topicid=5215
Just curious so i know where to start when i get the radio back, but i have not sent it yet.

-To help some out, the problem was the pitch servo locking up and not budging(this means i could not move the servo arm even by finger power)
03-04-2002 Over year old.
PROFILE   PM   EMAIL   POSTS   BUDDY   IGNORE   HOMEPAGE   GALLERY
 
 
rappyfly
Senior Heliman
Location: Toronto, ONT

My Posts This: Topic  Forum		Hi Victor

If the bell is rubbing on the clutch, I am sure it will make a lot radio noise. You shall notice it right the way and not since fall last year.
I remembered that I was helping you out at field when the engine was not running.
I can help you out by switching some of the radio stuffs. If you like, you can call me during the weekend.
03-05-2002 Over year old.
PROFILE   PM   EMAIL   POSTS   BUDDY   IGNORE   GALLERY
 
 
Vitya
Veteran
Location: North York, Ontario

My Posts This: Topic  Forum		Oh thanks so much, i would greatly appreciate that. It's been a big problem and i sure would like to see if it is the crystal but the problem is it hardly happens. I never know when the problem will show up. I think i will send in the radio but i will call you if i think of something that might show up the glitch. Thanks again
03-05-2002 Over year old.
PROFILE   PM   EMAIL   POSTS   BUDDY   IGNORE   HOMEPAGE   GALLERY
 
 
Wess94
Senior Heliman
Location: College Park, Md

My Posts This: Topic  Forum		Start shaft

If you drop the engine it`s a simple as just pushing up from the bottom of the start shaft and loosening the 2 setscrews on the start coupling. I would loctite them back in making sure they are on the 2 flat spots on the start shaft..while pushing up on the shaft you will need to push down in the coupler as you tighten the setscrews. good luck.

Wess
03-05-2002 Over year old.
PROFILE   PM   EMAIL   POSTS   BUDDY   IGNORE  
 
 
1 page550 viewsPOST REPLY
Power Helis . CANOMOD . Experience RC

.
.
Main Discussion > Could this be my problem?
 Print TOPIC Advertisers 

Subscribe to This Topic

Monday, November 23 - 1:57 pm - Copyright © 2000 - 2009 runryder.com | email | link to rr | START HERE | NF