wolfmeister
Heliman
Location: Mountain View, CA
My Posts This: Topic Forum | I had the same problem with my Logo 10. I filled the old holes and drilled new ones, but I didn't use CA glue. I was concerned that CA would be too brittle. Instead, I filled the holes with epoxy.
I layed the heli on its side and put a piece a normal Scotch tape on the frame to close the bottom of a set of the old holes. Next, I carefully filled the holes from the top with epoxy. After the epoxy dried, I removed the tape and ended up with relatively cleanly filled holes.
I filled my holes while the heli was otherwise fully assembled, so I had to do it in two passes, first one frame side, then the other.
I hope that helps. With my patch job, my Logo 10 has been holding together for about three years now.
In order to make an apple pie from scratch, you must first create the universe. -- Carl Sagan |
