RR Rated M For Mature
HOME   rrTV-PHOTO   GALLERIES   MY GALLERY   HELP-FAQ
myHOME PM pmRR MEMBERS 443 ONLINE 18 EVENTS SEARCH REGISTER  START HERE
 
1 page97 viewsPOST REPLY
Esprit Model . Thunder Power RC . Mikado Modellhubschrauber

.
.
e-Align T-REX 250-450-500-600 > T-REX 450 tail box question
 
 
iceman320
Senior Heliman
Location: utah

My Posts This: Topic  Forum		I recently had a crash with my exi 450 and had to setup the tail again, but when i give rudder input with my radio the heli will swing the tail around fast one way than the other? what could be the problem? and how do I fix it? thanks.

esky belt cp 450, just built exi 450 LE
11-06-2009 02:27 AM
PROFILE   PM   EMAIL   POSTS   BUDDY   IGNORE  
 
 
itsjojo
Veteran
Location: North East Pennnsylvania

My Posts This: Topic  Forum		Faster one way than the other? if this is the case things you can check. Look at the tail box. The pitch slider should be traveling both ways all the way to the stop. If you can turn off your gyro you should see your servo arm and arm on the tail at 90 degrees to the pushrod running down under the boom. The idea behind all this is to make sure the blade are moving all the way to the max position. If your blades are moving both ways equally then you can check your rudder neutral point.

In my set up process I set my gyro in rate mode and hover it to see which way the nose wants to drift. You want to slide the tail servo up or back on the boom, forward for right and back for left. Slide the tail servo and retest until the nose holds without moving. If your not sure about rate mode in your gyro you can turn off your gyro to do this but do not hover the heli, just spool it up until it gets light on it's skids and you'll see what way your nose wants to drift and then you can make corrections.

Also end points may adjust this problem but I keep my end points set at 100/100

Hope this helps.
Jojo

Trex 500esp 600N Pro & 700 Nitro Dx7
11-06-2009 08:01 AM
PROFILE   PM   EMAIL   POSTS   BUDDY   IGNORE   HOMEPAGE   GALLERY
 
 
str8den
Senior Heliman
Location: East U.K

My Posts This: Topic  Forum		did you twist the tail-drive belt in the wrong direction when you re-built it?
11-06-2009 03:21 PM
PROFILE   PM   EMAIL   POSTS   BUDDY   IGNORE  
 
 
iceman320
Senior Heliman
Location: utah

My Posts This: Topic  Forum		no, I didn't have to rebuild anything I just had to get the tail to hold again. and yes it swings the tail faster one way than the other way? so I will check out the things that were suggested? thanks for the help.

esky belt cp 450, just built exi 450 LE
11-06-2009 03:32 PM
PROFILE   PM   EMAIL   POSTS   BUDDY   IGNORE  
 
 
str8den
Senior Heliman
Location: East U.K

My Posts This: Topic  Forum		well, this is what i do to check things over;

1/ make sure tailrotor rotation is correct; not sure if this is the same for all helis, but all mine (T-rotors' turn anti clockwise viewing the heli from its RHS.

2/ check tail servo direction; again on my helis this means that a 'left-rudder' input from my tx 'pushes' the tail-control rod - ie; the TPS (tailpitch slider) will be moving 'right' towards the tail hub.

3/ now i check for 'gyro direction;' so what i do is take a firm hold of the heli and give it a sharp anti-clockwise rotation while observing the responce from the tail servo. the t/servo should 'pull' the tail control rod ie; the TPS should be moving toward the tailcase.

from this point (with the exception of mechanical set-up) everything else is adjusted from my tx. hope some of this might help you.
11-06-2009 04:04 PM
PROFILE   PM   EMAIL   POSTS   BUDDY   IGNORE  
 
 
1 page97 viewsPOST REPLY
Futaba-RC . Boca Bearings . XHELI.COM

.
.
e-Align T-REX 250-450-500-600 > T-REX 450 tail box question
 
 
Melnic
Key Veteran
Location: Columbia, MD,USA

My Posts This: Topic  Forum		Are you saying that when you spool up , it piros one way THEN the other.
(and you can't even get into a stable hover).

If this is the case, then you have something reversed mechanically or electronically.
Start w/ a bench test:
http://www.mycoolheli.com/gyrobenchtest.html


OR

Are you saying that it will piro FASTER one way then the other?
(You can hover fine, but the piro rate is faster in one direction than the other)

This could be your travel adjust settings, the servo centering or the travel limits possibly.
I also like itsjojo will hover in rate mode and then adjust my servo position on the boom to get near zero drift in an idle up hover.
11-06-2009 08:11 PM
PROFILE   PM   EMAIL   POSTS   BUDDY   IGNORE   GALLERY
 
 
1 page97 viewsPOST REPLY
Esprit Model . Thunder Power RC . Mikado Modellhubschrauber

.
.
e-Align T-REX 250-450-500-600 > T-REX 450 tail box question
 Print TOPIC Advertisers 

Subscribe to This Topic

Monday, November 23 - 11:33 am - Copyright © 2000 - 2009 runryder.com | email | link to rr | START HERE | NF