yeehawtex Heliman Location: kissimmeee,fl USA
My Posts This: Topic Forum | i own a esky belt driven cp v2.about five days ago i was in the front yard flying it,i decided to go down the side of the house and fly back there.i was flying along side the house then i finaly reached the back yard well a gust of wind hit my heli me being a new pilot i tried to correct it and over did the correction.my heli was about 6 to 7 feet in the air i was about 20 feet behind it IT CRASHED BOOM BANG it did the chicken the blades kept trying to spin even though i hit the throttle off when i hit the ground.its electric by the way.so i looked at it had a lot of bent parts(broken parts)fly bar,tail boom,blades,feathearing shaft,nuckle berrings where toast. thats all i think i wrecked.so i put new parts on beside new blades dont have a new set but i have a set of ok blades to use plastic is a little worn off.i went to take off after i fixed all of it and i hit the throttle and the tail started to spin ,i tried to adjust the rudder on my controller it didnt work.so i adjusted the servo its self still didnt work.so my tail starts to go out of control so i stoped it tried to adjust **** again and still wouldent work.i did not adjust my blade pitch though will that effect it?what do you guys think?tips tricks hint please help me if you know what i am talking about.i will post a video and whole bunch of pics latter tonight camera is dead.and a video so you guys can see what i mean,by it wont stop spinning. |