doorman
Elite Veteran
Location: E.Berne, NY
My Posts This: Topic Forum | Mounting Info...Here you go splitboarder.... sorry it took me so long to put these up....
As you can see, I changed the mounting screws to 2.5mm bolts with nyloc nuts that I ca'd to the frame after cutting away the "little" humps that the original screws went into.....
I did use the holes as supplied and it seemed to work fine..
I also added 1/16" plywood across the bottom of the frames, also ca'd to the frame.... I used a single thickness at the rear and double at the front.....by doing the set up this way, it is a very simple and easy install and remove if need be...
All you need to do is to remove the top rear bolt at the 45 and remove the tail case, the four front bolts and out it comes....
The original tail boom needs to be cut to 30.8 cm... (Thanks ea01bg)
Do the belt tension while out of the fuselage with the 45 attached and all working, and tighten it all up... then pop the tail case and the top bolt at the 45 and you will have it....
You will also notice the brass tubing running up to the side frame from the top of the servo tray on the left side, and on the right side it goes to the bottom of the fuselage floor with a piece of 1/16" plywood and epoxy... makes for a nice smooooooth flier!!!!
I did also, as you mentioned, cut the doghouse top rear so that the anti-rotation pin would not hit.... added some Xtec Lighting, some screen in the sides and front and there you have it....
This is one nice little heli, that looks GREAT just tooling around our indoor area, and no reason not to fly it outdoors either.....
Good Luck,  Stan
       
Team Hirobo/MRC --- RCLIGHTS.NET ----- If there is a cure for this, please don't tell me about |
