RunRyder RC Helicopter Topic - os 37 temp in hawk

RR Rated M For Mature

HOME rrTV-PHOTO GALLERIES MY GALLERY HELP-FAQ

myHOME PM pmRR MEMBERS 834 ONLINE 82 EVENTS SEARCH REGISTER START HERE

1 page

144 views

POST REPLY

XHELI.COM	.	Advantage Hobby	.	Revolution Models
	.		.

Century Radikal - Hawk - 50NX - Predator > os 37 temp in hawk

jim 73strat
Heliman
Location: Perth Western Australia

My Posts This: Topic Forum

How long should I be able to hold my finger on the back plate of my os 37 in my century hawk when i have been hovering for a few mins? At the moment it is only 3-5 seconds. I can richen it up to make it cooler but it just does not seem to run very well on a rich setting. It is going really well just the way it is but I am just concerned it could be a running a bit hot.

WA

11-03-2009 01:16 PM

PROFILE PM EMAIL POSTS BUDDY IGNORE

FBoss
Elite Veteran
Location: Aurora Indiana USA

My Posts This: Topic Forum

Thats a bit short. Most say 5-6 sec. If it runs good at that setting try riching the idle needle (screw driver needle)but just ever so slightly, less than a 1/16 turn. 2-3 sec is too lean for sure and you can get that 37 to run very very good. Its a good motor

The good ole times are now ,Hawk, Raven,NX50, Logo10,Swift

11-03-2009 01:52 PM

PROFILE PM EMAIL POSTS BUDDY IGNORE GALLERY

Dilbeck
Elite Veteran
Location: Springdale Arkansas

My Posts This: Topic Forum

Hovering at a low head speed will be different than a full all out run. It will heat up totally different at higher head speeds. Your probably fine at a hover speed but watch out as the heat will rise at higher rpm.. Also the engine will heat up when shut down VS running, (heat soak). So check it as soon as possible from a run.

Clint

11-04-2009 02:46 AM

PROFILE PM EMAIL POSTS BUDDY IGNORE GALLERY

1 page

144 views

POST REPLY

CarbonXtreme	.	Midland Helicopters	.	HeliProz
	.		.

Century Radikal - Hawk - 50NX - Predator > os 37 temp in hawk

Print TOPIC

Advertisers

Subscribe to This Topic