oragami
Senior Heliman
Location: Florida
My Posts This: Topic Forum | Okay. Simple answer for you.
Your Radial Bearings (2) should be fixed in the grips, if they are, then you have to build the Thrust Bearings on top of the Radials. If you have only one Radial Bearing installed from the Factory, then use the Build Illustration that shows that system.
I hope that Made sense.
Also, The Dampners. You are so right about them. I had the same problem with getting my spindle through them. But I finally did it with some Tri flow and a little bit of heat.
Also. Make sure that the dampners are seated flush with the outside of the Head block, or your thrust bearings will not be free.
Hope this helps.
Craig |
