jschenck
rrProfessor
Location: La Vista, NE.
My Posts This: Topic Forum | The Heli Direct screw set is what I used also - I have grinded down the head of the screws and washers on the rear of the main bearing blocks to clear the linkages. I did this by holding the screw and cap with a pair of pliers while pressing them into the disk sander I have. I don't think this is an issue with the new liron set.
I haven't done this on the lower rear bolts yet but they also need the same treatment. Some just run the stock bolts there but I chose to do this.
.. P-gas, T700, V50c/u, R50T, T4/250 and a Cricket .. |
